Canada
USA
Japan
- MATERIAL: 16 GAUGE POWDER COATED MS CRC SHEET METAL STRUCTURE.
- SHOES: PVC BOOTS IN LEGS FOR BETTER BALANCE AND NOISE REDUCTION ON FLOOR
- TABLE TOP & SEAT/BACK MATERIAL: SUN-MICA PASTED OVER 18/25 MM THICK COMMERCIAL PLY/ PLBP WITH 2 MM THICK PVC EDGE-BANDING TAPE ON ALL EXPOSED EDGES.
- PERFORATED SHEET METAL MODESTY.
- COLOR: AS PER DEMAND
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
DESK AND BENCH DESIGN
OVERALL DIMENSIONS: L–900MM, B– 650MM, H– 600MM.
LAMINATED WITH DECORATIVE LAMINATION ONE SIDE AND OTHER SIDE BALANCING LAMINATION EXTERIOR GRADE-1 MDF BOARD 18 MM THICK CONFIRMING TO IS:14587(DSR 9.157.1).
- PROVIDING AND FIXING PRE-LAMINATED FLAT PRESSED 3 LAYER (MEDIUM DENSITY) FIBER BOARD IS: 14587:1998 MARKED WITH ONE SIDE DECORATIVE AND OTHER SIDE BALANCING LAMINATION GRADE I (EXTERIOR GRADE), IN SHELVES WITH SCREWS AND FITTINGS WHEREVER REQUIRED, EDGE TO BE PAINTED WITH PVC EDGE BANDING TAPE 2 MM THICK OF APPROVED BRAND HARDWARE & FITTINGS.
UNDER-STRUCTURE / BASE FRAME:
- BASE OF FRAME CONSIST OF HOLLOW MS PIPE OF SIZE 50 MM X 25 MM WITH WALL THICKNESS 1.2 MM @ 1.37 KG/M.
- VERTICAL AND HORIZONTAL MEMBERS OF FRAME IS CONSISTING OF HOLLOW MS PIPE OF SIZE 25MM X 25MM WITH WALL THICKNESS 1.2MM @ 0.9 KG/M. MS TUBE FOR BACKREST SUPPORTS SHALL BE OF 25MM DIAMETER CIRCULAR PIPE @ 0.9 KG/M. SIDE COVER AND MODESTY OF DESK SHALL BE 0.8MM THICK CRCA (COLD ROLLED CLOSE ANNEALED) SHEET @ 6.28 KG/M2.
- SIDE HOOKS / HANGERS FOR WATER BOTTLES / SCHOOL BAGS TO BE PROVIDED ON EXTERNAL PART OF CRCA STRUCTURE FACING OUTSIDE.
- POWDER COATING FOR MS FRAME WITH 50 MICRON (±10).
ADDITIONAL SPECIFICATION:
- ADJUSTABLE LEVEL TO BE PROVIDED AND ATTACHED TO THE BASE FRAME SURFACE.
- PVC CAPS TO BE USED TO COVER ALL HOLLOW SECTIONS OPEN END OF MS PIPE.
- ALL THE CORNERS IN MDF BOARD, MS SECTIONS AND CRC SHEETS SHOULD BE ROUNDED TO AVOID AND CASUALTIES.
- ALL MEMBERS OF THE FRAME SHALL BE CONNECTED BY ELECTRIC WELDING WHILE FABRICATING OR THE BIDDER CAN USE KNOCKDOWN TECHNIC FOR FABRICATION FOR BETTER FINISHING.
- FURNITURE CAN BE ELECTRICALLY KNOCK-DOWN.
- IN CASE OF KNOCK FURNITURE ALL THE FITTINGS / NUTS / BOLTS/ RIVETS SHOULD BE MADE UP OF SS TO CONNECT DIFFERENT MEMBERS OF THE THREE BENCHES.
- THE MEMBER FOR SUPPORTING THE BACKREST PANEL OF THE BENCH SHALL NOT BE MORE-THAN 10º INCLINED BACKSIDE WITH A VERTICAL AXIS.
- THE STORAGE SELF SHALL BE FABRICATED AS PER THE DESIGN.
- BACK SUPPORT SEATING MATERIAL: WITHOUT CUSHION.
